News Details
Home> News Details
How do I adjust and check the copper in a swimming-pool ?
Date: 2019-08-20
Click: 96
Author: Hymatic
- Measure the copper in the water when full. If your pool is a different size, you need to amend the program using the following table:These times are for guidance.

We recommend that copper in the pool should be held at around 0.5 mg/l. To achieve this, you should check the program and verify water's copper content when starting up, and for the first few weeks.

Follow the steps below to do this.

- Measure the copper in the water when full. If there is copper, we need to take this into account when carrying out programming.
- The equipment leaves the factory with nominal programming for pool sizes 80, 125, 175 and 400 m3. If your pool is a different size, you need to amend the program using the following table:

These times are for guidance. They may need to be increased or decreased, depending on the measurements obtained.
Consult the manual to amend the program, depending on the model.

Previous: How do I render rapid-impact chlorination effective?
Next: Problems with excessive copper: the solution:
[ Close]   [ Print ]

Copyright(C)Hymatic